Jump to content
Sign in to follow this  
jima1

CLOSED Custom panel appearance / FSUIPC Lua LVars

Recommended Posts

Hello,

Is it possible to have custom size/appearance of the radar panel?
I am asking because we have real DC-9 weather radar and using micro projector to display the radar panel on the screen, but it does not fit. What I need is a radar screen only without the bezel/buttons.
Other question: is it possible to control the radar control switches and get their state using FSUIPC and LVars?
Thanks

Jindřich

Share this post


Link to post
Share on other sites

For the display only without the controls, use the MV_WX!WX gauge entry in the panel cfg without the MV_WX!WX2D gauge entry.

For the controls, I don't think I made a way to control them directly. However, you can read the control states using the following L vars, and increment/decrement them using the following key events:

(L:WX_Radar_Range, number)

Range is 0 to 5 (5nm to 160nm, each increment being double the previous range)

Increment event: 0x14001

Decrement event: 0x14000

(L:WX_Radar_ModeSelect, number) 
0 to 4 (Off, Stby, WX, WXT, MAP)
Increment: 0x14003

Decrement: 0x14002

(L:WX_Radar_Tilt, number)

-15.0 to 15.0 degrees in 0.5 deg increments

Increment: 0x14005

Decrement: 0x14004

(L:WX_Radar_BRT, number)

0 to 100

Increment: 0x14007

Decrement: 0x14006

(L:WX_Radar_Gain, number)

0 to 100

Increment: 0x14009

Decrement: 0x14008

Share this post


Link to post
Share on other sites

I am just checking in to see if the issue you are experiencing has been resolved?

Share this post


Link to post
Share on other sites

Can we mark this issue resolved or closed?

Share this post


Link to post
Share on other sites

This item has been closed without a resolve or confirmation of resolve by the customer.

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

  • Recently Browsing   0 members

    No registered users viewing this page.

  • See our many awards!

×
×
  • Create New...