Jump to content
jetfish

CLOSED Jetway Elevation

Recommended Posts

Hi, at some of the airports the jetways are not positioned properly. They are much to high "flying"
On other airports it is just fine.  See picture attached. Any idea how to fix this?

Using P3DV4.3, ORBX Base and Vector and LC Europe, SODE 1.6.3.

Madrid.jpg

Naples.jpg

Helsinki.jpg

Athens.jpg

Share this post


Link to post
Share on other sites

Hi, 

This is a GSX issue and you will have to inquire for support from them. 

Share this post


Link to post
Share on other sites

This appears to be caused by GSX not being compatible with Orbx Vector AEC. Disable the new jetways

Share this post


Link to post
Share on other sites
On 10/7/2018 at 7:47 PM, dlrk said:

This appears to be caused by GSX not being compatible with Orbx Vector AEC. Disable the new jetways

@jetfish, has this helped? Thank you @dlrk

 

  • Like 1

Share this post


Link to post
Share on other sites

I am just checking in to see if the issue you are experiencing has been resolved?

Share this post


Link to post
Share on other sites

From my knowledge (and direct experience) it is resolved using the ORBX setting elevator tool inside FTX Central.

After an installation of an ORBX scenery it is necessary to run the Airport elevation tool.

This should fix the elevation issue compared to the around ground level. But it does not affect the GSX jetways.

So it happens that, sometime, in some airports, you find the jetways made by GSX at a wrong level.

In this case it is necessary to use the FTX elevation tool in the manual configuration (not automatic) . You have to select in the list of all the airports the one (or more) having the issue. You can exlude them by the automatic elevation tool and then apply.

It solves the issue that is not a REX airport issue.

Share this post


Link to post
Share on other sites
33 minutes ago, Stefano Biasiotti said:

From my knowledge (and direct experience) it is resolved using the ORBX setting elevator tool inside FTX Central.

After an installation of an ORBX scenery it is necessary to run the Airport elevation tool.

This should fix the elevation issue compared to the around ground level. But it does not affect the GSX jetways.

So it happens that, sometime, in some airports, you find the jetways made by GSX at a wrong level.

In this case it is necessary to use the FTX elevation tool in the manual configuration (not automatic) . You have to select in the list of all the airports the one (or more) having the issue. You can exlude them by the automatic elevation tool and then apply.

It solves the issue that is not a REX airport issue.

Hi Stefano, thank you for posting this information.

  • Like 1

Share this post


Link to post
Share on other sites

  • Recently Browsing   0 members

    No registered users viewing this page.

  • See our many awards!

×
×
  • Create New...